Vinyl Decal Application Instructions


Thank you for purchasing one of our vinyl decals! If you have any questions, please feel free to contact us via e-mail, we'd be happy to help.

Step One
Make sure you don't apply your vinyl decal to vehicles or smooth outdoor surfaces during extreme hot or cold weather. Clean the area thoroughly with rubbing alcohol, or soap and water. Windex or commercial cleaner is not recommended as it can leave behind a residue that will prevent the sticker from adhering well. If you use soap and water, please allow to dry properly.

Step Two
Rub a debit/credit/store card firmly across the front and back of the decal to prepare it for application. This ensures the decal will cling to the transfer tape and remove any air bubbles that may have formed. 

Step Three
Remove the patterned paper away from the transfer tape. The decal should be adhering only to the semi transparent transfer tape. If it hasn't all stuck, restick to the backing and rub several times, front and back. Repeat process in Step Two.

Step Four
Lower the decal onto the surface and rub in place using that same rigid card, rub over the entire surface thoroughly.

Step Five
Slowly peel the transfer tape away at an angle, not straight up and down. Be careful not to pull the decal off the surface. If sticker pulls away, repeat Step Four until applied.


Leave a comment


Please note, comments must be approved before they are published